|
|
| PUSH-IN FITTINGS WITH METAL COLLET |
|
|
|
Component Parts and Materials
1 Nickel-plated brass Body
2 Nickel-plated brass Collet
3 Nickel-plated brass Capsule
4 Steel aisi 301 Clamping washer
5 Technopolymeric Safety ring
6 NBR 70 Lip seal (if requested FKM)
7 NBR 70 Thread packing (if requested FKM)
|
|
Connection Tubes
Plastic tubes:
PA6, PA11, PA12, Polyethylene, *Polyurethane, ecc.
*For Polyurethane hoses it is required a minimum hardness of 98 shore. |
Temperatures
Minimum temperature -20 °C
Maximum temperature +80 °C |
Threads
"Short" taper thread.
Tapered gas in conformity with ISO7.1, BS 21, DIN 2999
Parallel gas in conformity with ISO 228 Class A
|
Pressures
Minimum pressure:
-0.99 bar (-0.099 Mpa)
Maximim pressure:
15 bar (1.5 Mpa) |
Fluids
Compressed Air, Vacuum, Steam with FKM o-ring, Water. |
Fittings are available in the following sizes:
tube from 4 up to 14;
thread of M5 up to 1/2.
|
|
|
The clamping washer made in stainless steel ensure the perfect tube clamping with every kinds of materials without damage the surface.
The connection between the tube and the fitting ensure a total tightness even in severe conditions such as impact and vibrations.
The particular geometric shape of the seal ensure the perfect tightness even with vacuum.
|
| |
|
| All of threads from this range (also the M5), have been equipped with tightening parts which allow the direct assembly of the fittings, reducing the installation time. |
|
| |
|
|
|
All the straight fittings, with taper and parallel threads can be assembled also with Allen wrench and it is possible to use them in reduced spaces. |
|
