Catalogue

---

The sattle clamp connector allow to realize a new tube of outlet in a system already installed without removing Pipes. For the installation, follow the instructions:

	Depressurize the system.
	Position the drilling jig (Art.90242) of boring on the tube. Take care of the correct position of the drilling jig: the guide hole for the boring tool must be perpendicular to the axes of the tube of outlet which you want to add. It is possible to connect a tube diameter 20 to take easier the positioning of the drilling jig. Close the screw to avoid that the drilling jig could move on the tube.
	Bore the tube with the proper boring tool (Art.90241).
	Take care of not damage the opposite side of the tube. Disassemble the drilling jig from the tube. Fraze the tube and remove possible residual material.
	Assemble and screw the sattle clamp connector  (Art.90240) on the tube in order that the leap seal is connected correctly on the hole.
	Tight the screw to complete the mounting.